EasyManua.ls Logo

Ninebot S - Page 8

Ninebot S
21 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
4 Assembling
1 Insert the steering bar Into the steering
socket at the back of the mainframe
Check the Power ON/OFF status after assembly
6 First Ride
2 Install the two screws Tighten
securely with the included hex
wrench
0
3
Snap the lid securely with hearing
the sound of "click"
0
There are safety risks when learn.ng ta ride the Ninebat S You must read the Safety Instructions and
follow the New Rider Tutorial in the App before your first ride
For your safety. your Ninebot S is not activated at this time and will beep occasionally after Power ON
Until activated. the Ninebot S maintains a very low riding speed and steering sensitivity. and should not be
ridden Install the App on your mobile device (with Bluetooth 4 2 or above), connect to the Ninebot S with
Bluetooth, and follow the App instructions to activate your Ninebot S and follow the training procedures
Scan the QR code to download the App (iOS 8.0 Or above, AndroidTM 4.3 or above).
A Foryoursafety,yourNinebotSisnotactivatedatthistimeandwil beepoccasionallyafterPowerON Untilactivated,the
Ninebot S maintains a very low riding speed and steering sensitivity. and should not be ridden Install the Segway Ninebot
App on your mobile device (with Bluetooth 4 2 or above), connect to the Ninebot S with Bluetooth, and follow the App
Instructions to activate your Ninebot S and follow the training procedures
5 Charging
DO not connect the charger if the charge port or charge cable is wet The battery pack is only to be charged by adults
nsta
App and register/ login
2 Power ON the Ninebot S The Bluetooth icon
blinking indicates the Ninebot S is waiting for
a connection
3
n the APP, click Vehicle, scan and select your
Ninebot S The Ninebat S will beep when the
connection is successful The Bluetooth icon wil
stop blinking and remain illuminated
Charge Port
Lift up the cover Open the rubber
cap
nsert the plug
into the socket
•Your Ninebot S is fully charged when the LED on the charger changes from red (charging) to green (trickle charge) Close
the rubber Cap when not charging

Related product manuals