29
CARE & MAINTENANCE
CLEANING
1 Separate all parts.
2 Wash all containers in warm, soapy water
with a soft cloth.
3 Hand Washing
Wash blade assemblies in warm, soapy
water using a dishwashing utensil with
a handle or the provided cleaning brush
to avoid direct contact with the blades.
Exercise care when handling blade
assemblies as the blades are sharp.
Thoroughly rinse and air-dry all parts.
Dishwasher
All attachments are dishwasher safe. It is
recommended that the lids, containers, and
blade assemblies be placed on the top rack
of the dishwasher ONLY. Ensure the blade
assemblies are removed from their containers
before placing in the dishwasher. Exercise
care when handling blade assemblies.
Motor Base
Turn off the unit and unplug the motor base
before cleaning. Wipe motor base with a
clean, damp cloth.
Clean the touchscreen with a soft cloth,
such as microfiber, to prevent scratching. To
remove residue from the touchscreen, you
may use an all-purpose cleaner.
NEVER spray the base or touchscreen with
water or other liquids.
DO NOT use abrasive cloths/pads/brushes
to clean the base or touchscreen, as this
can dull or scratch the surface.
STORING
Wrap the power cord around the cord wrap
on the back of the motor base. Store the unit
upright and store all blade assemblies inside or
attached to their respective containers with their
lids locked into place.
DO NOT store blended or unblended
ingredients in the High-Speed Blender Cup with
the Pro Extractor Blades
®
assembly attached.
DO NOT stack items on top of the containers.
Store any remaining attachments alongside
the unit or in a cabinet where they will not be
damaged or create a hazard.
RESETTING THE MOTOR THERMOSTAT
This unit features a unique safety system
that prevents damage to the motor and drive
system should you inadvertently overload the
it. If the unit is overloaded, the motor will be
temporarily disabled. Should this occur, follow
the reset procedure below.
1 Unplug the unit from the electricaloutlet.
2 Allow the unit to cool for approximately 15
minutes.
3
Remove the container’s lid and blade
assembly. Empty the container and ensure no
ingredients are jamming the blade assemblies.
IMPORTANT: Ensure that maximum
capacities are not exceeded. This is the
most typical cause of appliance overload.
If your unit needs servicing, please call
Customer Service at 1-877-646-5288.
ORDERING REPLACEMENT PARTS
To order additional parts and attachments,
please visit ninjaaccessories.com or contact
Customer Service at 1-877-646-5288.
To Next Page
Loading...
Need help?
General
