Follow these steps to install a rear-facing child
restraint using the vehicle seat belt in the rear
seats:
1. Child restraints for infants must be used
in the rear-facing direction and there-
fore must not be used in the front seat.
Position the child restraint on the seat. Always
follow the child restraint manufacturer’s
instructions.
2. Route the seat belt tongue through the child
restraint and insert it into the buckle until you
hear and feel the latch engage. Be sure to
follow the child restraint manufacturer’s in-
structions for belt routing.
3. Pull the shoulder belt until the belt is fully
extended. At this time, the seat belt retractor
is in the ALR mode (child restraint mode). It
reverts to the ELR mode when the seat belt is
fully retracted.
Rear-facing — step 1 Rear-facing — step 2 Rear-facing — step 3
1-26 Safety–Seats, seat belts and supplemental restraint system
To Next Page
Loading...
