tongue is released from the connector
buckle. Release the connector tongue by
inserting a suitable tool such as a key
䊊
2
into
the connector buckle.
2. Retract the seat belt and store the seat belt
tongue on the stowed position
䊊
3
.
WARNING
Do not unfasten the rear center seat belt
connector except when folding down the
rear seat.
Attaching the center seat belt
Always be sure the center seat belt connector
tongue and connector buckle are attached. Dis-
connect only when folding down the rear seat.
To connect the buckle:
1. Pull the seat belt tongue and connector
tongue from the stowed position
䊊
1
.
2. Pull the seat belt and secure the connector
buckle until it clicks
䊊
2
.
The center seat belt connector tongue can be
attached only into the rear center seat belt con-
nector buckle.
To fasten the seat belt, refer to “Fastening the
seat belts” in this section.
LRS8101
Safety—Seats, seat belts and supplemental restraint system 1-17
To Next Page
Loading...