CAUTION
• Do not slide the shift lever while push-
ing the P position switch. This may
also damage the electric motor.
• When switching to the preferred posi-
tion by operating the shift lever, check
that the shift lever returns to the cen-
tral position by releasing your hand
from the lever. Holding the shift lever
in a mid-way position may also dam-
age the shift control system.
• Do not operate the shift lever while the
accelerator pedal is depressed, except
when switching to the ECO position.
This may cause a sudden start which
could result in an accident.
•
The following operations are not allowed
because excessive force would be ap-
plied to the traction motor and this may
result in damage to the vehicle:
– Moving the shift lever to the R (Re-
verse) position when driving for-
ward
– Moving the shift lever to the D
(Drive) or ECO position when revers-
ing
If these operations are attempted, a
chime sounds and the vehicle shifts to
the N (Neutral) position.
P (Park):
Use this shift position when the vehicle is parked
or when placing the vehicle in the READY to drive
position. Make sure that the vehicle is completely
stopped. In order to switch to the P (Park)
position, press the P (Park) position switch
as shown in the illustration above once the
vehicle has come to a complete stop. If the
P (Park) position switch is pressed while
the vehicle is in motion, a chime sounds
and the current shift position is main-
tained. After switching to the P (Park) position,
apply the parking brake. When parking on a hill,
apply the parking brake first while keeping the
foot brake pedal depressed then push the P
(Park) position switch and place the vehicle in the
P (Park) position. See ⬙Parking brake⬙.
NOTE:
• While the vehicle is stationary, if the shift
position is placed in any position other
than the P (Park) position when the power
switch is set to OFF, it will automatically
switch to the P (Park) position.
• If the P (Park) position switch is pressed
while sliding the shift lever, the shift posi-
tion will not switch to the P (Park) posi-
tion. When pressing the P (Park) position
switch be sure to first allow the shift lever
to return to its center position.
R (Reverse):
Use this position to back up. Make sure that the
vehicle is completely stopped before selecting
the R (Reverse) position. If the vehicle is
placed in the D (Drive) position while re-
versing, the chime will sound and the ve-
hicle will switch into the N (Neutral) posi-
tion.
Starting and driving 5-13
To Next Page
Loading...
