[ Edit: 2016/ 11/ 24 Model: E12-A ]
5-10 Starting and driving
wheel cannot be unlocked. Do not move the vehicle
with the steering wheel locked.
If the shift lever cannot be moved out of the “P” (Park)
position, have a NISSAN dealer check the CVT system
as soon as possible.
WARNING:
If the shift lever cannot be moved from the “P”
(Park) position while the engine is running and
the brake pedal is depressed, the stop lights
may not work. Malfunctioning stop lights could
cause an accident injuring yourself and others.
High fluid temperature protection mode
E12-A-120227-A85E3B39-5AD8-4A73-92F2-8C71C1164F44
This transmission has a high fluid temperature protec-
tion mode. If the fluid temperature becomes too high
(for example, when climbing steep grades in high
temperature with heavy loads), engine power and,
under some conditions, vehicle speed will be de-
creased automatically to reduce the chance of
transmission damage. Vehicle speed can be controlled
with the accelerator pedal, but engine and vehicle
speed may be limited.
Fail-safe
E12-A-120227-432D849F-9460-4991-8CCE-2AE0948E0865
When the fail-safe operation occurs, the CVT will not
be shifted to the selected driving position.
If the vehicle is driven under extreme conditions,
such as excessive wheel spinning and subse-
quent hard braking, the fail-safe system may be
activated. This will occur even if all electrical
circuits are functioning properly. In this case,
place the ignition switch in the “OFF” position
and wait for 10 seconds. Then turn the ignition
switch back to the “ON” position. The vehicle
should return to its normal operating condition.
If it does not return to its normal operating
condition, have a NISSAN dealer check the
transmission and repair it if necessary.
WARNING:
When the fail-safe operation occurs, vehicle
speed may be gradually reduced. The reduced
speed may be lower than other traffic, which
could increase the chance of a collision. Be
especially careful when driving. If necessary, pull
to the side of the road at a safe place and allow
the transmission to return to normal operation,
or have it repaired if necessary.
E12-A-120227-17A8CB2F-898F-47AD-A6AA-4D4468662CBA
The Idling Stop System activates to prevent unneces-
sary fuel consumption, exhaust emissions and noise.
. The Idling Stop System stops the engine auto-
matically when the vehicle stops.
. When you start the vehicle again, the engine is
turned on automatically.
CAUTION:
When the vehicle is moved while the engine is
stopped by the system, such as on a downhill
grade, the engine restarts automatically. To
avoid an accident, be sure to depress the brake
pedal.
NOTE:
The Idling Stop System will not operate under
the following conditions:
. when the engine is kept idling without any driving
after the engine is turned on.
. when the engine coolant temperature is low.
. when the battery capacity is low.
. when the battery temperature is low or extremely
high.
. when a negative pressure booster decreases.
. when the engine hood is opened with the engine
running.
. when the engine is turned on with the engine hood
open.
. when the driver’s seat belt is not fastened.
. when the driver’s door is open.
. when the steering wheel is operated.
. when the Idling Stop System indicator blinks at a
low speed.
IDLING STOP SYSTEM
Condition:
To Next Page
Loading...