[ Edit: 2016/ 11/ 24 Model: E12-A ]
JVE0298X
1. Shake the sealant bottle well.
2. Remove the cap on the bottle and screw the
sealant filler tube into the bottle.
3. Remove the cap of the valve on the flat tire, and
deflate the tire completely by pushing the valve
core using the valve core tool.
4. Remove the valve core carefully using the valve
core tool. Keep it free of dirt.
5. Insert the tube into the tire valve.
6. Hold the bottle upside down and squeeze it
repeatedly until the sealant is injected into the tire.
After the sealant is completely injected, pull the
tube out of the valve. Install the tire valve core
securely into the valve using the valve core tool.
Do not throw away the empty sealant bottle.
This bottle is necessary when the tire is
repaired or replaced by a NISSAN dealer.
7. Firmly screw the tire valve core tool into the end of
the tube to prevent the sealant from leaking out of
the empty sealant bottle.
JVE0289X
8. Put the speed restriction sticker in a location
where the driver can see it while driving.
CAUTION:
Do not put the speed restriction label on the
steering wheel pad, the speedometer or the
warning light locations.
JVE0300X
9. Screw the tube of the air compressor securely into
the tire valve
*
A
. Insert its power plug to the
power outlet
*
B
in the vehicle. Place the ignition
switch in the “ACC” position. Then turn on the
compressor, and inflate the tire to the pressure
that is specified on the tire placard affixed to the
In case of emergency 6-7
Condition:
To Next Page
Loading...