[ Edit: 2016/ 11/ 24 Model: E12-A ]
JVE0057X
1. If the booster battery is in another vehicle
*
B
,
position the two vehicles
*
A
and
*
B
to bring the
batteries into close proximity to each other.
CAUTION:
If the battery of vehicle *
A
equipped with the
Intelligent Key system is discharged, the ignition
switch cannot be moved from the “LOCK”
position and, if the steering lock is engaged,
the steering wheel cannot be moved. Connect
the jumper cables to the booster vehicle
*
B
before turning the ignition switch and disenga-
ging the steering lock.
2. Apply the parking brake.
3. Move the shift lever to the “P” (Park) position.
4. Switch off all unnecessary electrical systems
(headlights, heater, air conditioner, etc.).
5. Place the ignition switch in the “LOCK” position.
6. Remove the vent caps, if equipped, on the battery.
7. Cover the battery with a firmly wrung out moist
cloth to reduce the hazard of an explosion.
8. Connect the jumper cables in the sequence as
illustrated (
*
1
,
*
2
,
*
3
,
*
4
).
CAUTION:
. Always connect positive + to positive + and
negative 7 to body ground, NOT to the
battery’s negative 7.
. Be sure that the jumper cables do not touch
moving parts in the engine compartment.
. Be sure that the jumper cable’s clamps do
not contact any other metal.
9. Start the engine of the booster vehicle
*
B
and let
it run for a few minutes.
10. Depress the accelerator pedal of the booster
vehicle
*
B
at about 2,000 rpm.
11. Start the engine of the jumped vehicle
*
A
in the
normal manner.
CAUTION:
. Never keep the starter motor engaged for
more than 10 seconds. If the engine does not
start right away, place the ignition switch in
the “OFF” position and wait at least 10
seconds before trying again.
. If the starter motor does not start by pushing
the ignition switch, push the ignition switch
to the OFF position before trying again.
12. After the engine is started, carefully disconnect
the jumper cables in the opposite sequence from
that illustrated (
*
4
,
*
3
,
*
2
,
*
1
).
13. Remove and dispose of the cloth as it may be
contaminated with corrosive acid.
14. Replace the vent caps, if removed.
NOTE:
. Use the special battery that is enhanced in
regard to the charge-discharge capacity and
life performance. Avoid using a non-special
battery for the Idling Stop system, as this
may cause early deterioration of the battery
or a malfunction of the Idling Stop system.
For the battery, it is recommended to use
Genuine NISSAN parts. For more informa-
tion, contact a NISSAN dealer.
. It may take some time until the Idling Stop
System activates when the battery is re-
placed or the battery terminal is discon-
nected for extended periods and then
reconnected.
In case of emergency 6-9
Condition:
To Next Page
Loading...