[ Edit: 2016/ 11/ 24 Model: E12-A ]
8-10 Maintenance and do-it-yourself
4. Loosen the oil filter with an oil filter wrench.
Depending on the engine model, a special cap
type wrench may be required. See a NISSAN
dealer for more information.
5. Remove the oil filter by turning it by hand.
6. Wipe the engine oil filter mounting surface with a
clean cloth.
Be sure to remove any old gasket remaining on the
mounting surface.
7. Apply the new engine oil to the gasket of the new
oil filter.
8. Screw in the oil filter until a slight resistance is felt,
and then tighten an additional 2/3 of turn to
secure the oil filter.
Oil filter tightening torque:
15 to 20 N·m (11 to 15 ft-lb)
9. Refill the engine oil. (See “Engine oil replacement”
(P.8-8).)
10. Start the engine and check for leakage around the
oil filter. Correct as required.
11. Turn the engine off and wait several minutes.
12. Check the engine oil level according to the proper
procedure. (See “Checking engine oil level” (P.8-
7).)
PROTECT ENVIRONMENT
E12-A-120227-E61F90FA-EAEF-4870-9F1A-4748039A281F
It is illegal to pollute drains, watercourses and soil. Use
authorized waste collection facilities, including civil
amenity sites and garages providing facilities for
disposal of used oil and used oil filters. If in doubt,
contact your local authority for advice on disposal.
The regulations concerning the pollution of the
environment will vary from country to country.
E12-A-120227-B4EFFDAE-6C58-47F0-A6C6-C9F1CA299FD4
HR12DE ENGINE MODEL
E12-A-120227-BD5B969E-7D27-4A47-B205-859B9CEE465C
SDI2573
HR12DE engine
1. Water pump
2. Alternator
3. Crankshaft pulley
4. Air conditioner compressor
!: Tension checking point
Be sure the ignition switch is in the “OFF” position.
Visually inspect each belt for signs of unusual wear,
cuts, fraying or looseness. Check regularly for condi-
tion and tension. If the belt is in poor condition or loose,
have it replaced or adjusted by a NISSAN dealer.
HR12DDR ENGINE MODEL
GUID-F7A06E6F-FE2B-43D7-B926-1722EC3B0D43
JVM0061X
HR12DDR engine
1. Supercharger
2. Water pump
3. Alternator
4. Electromagnetic clutch
5. Crankshaft pulley
6. Drive belt auto-tensioner
7. Air conditioner compressor
Be sure the ignition switch is in the “OFF” position.
Visually inspect each belt for signs of unusual wear,
DRIVE BELTS
Condition:
To Next Page