[ Edit: 2016/ 11/ 24 Model: E12-A ]
SSS0134A
SSS0136A
SSS0014
SSS0016
WARNING:
. Seatbelts are designed to bear upon the
bony structure of the body, and should be
worn low across the front of the pelvis or the
pelvis, chest and shoulders, as applicable;
wearing the lap section of the belt across
the abdominal area must be avoided. Ser-
ious injury may occur if a seat belt is not
worn properly.
. Position the lap belt as low and snug as
possible around the hips, not the waist. A
lap belt worn too high could increase the
risk of internal injuries in an accident.
. Do not allow more than one person to use
the same seat belt. Each belt assembly must
only be used by one occupant; it is danger-
ous to put a belt around a child being carried
on the occupant’s lap.
. Never carry more people in the vehicle than
there are seat belts.
. Never wear seat belts inside out. Belts
should not be worn with straps twisted.
Doing so may reduce their effectiveness.
. Seatbelts should be adjusted as firmly as
possible, consistent with comfort, to provide
the protection for which they have been
designed. A slack belt will greatly reduce the
protection afforded to the wearer.
. Every person who drives or rides in this
vehicle should use a seat belt at all times.
Children should be properly restrained in the
rear seat and, if appropriate, in a child
restraint system.
Safety — seats, seat belts and supplemental restraint system 1-7
Condition:
To Next Page
Loading...