[ Edit: 2016/ 11/ 24 Model: E12-A ]
OPENING HOOD
E12-A-120227-A03D3982-C98B-4C2A-B61D-A669C570C6D2
JVP0276X
1. Pull the hood lock release handle
*
1
located
below the instrument panel until the hood springs
up.
2. Locate the lever
*
2
in between the hood and
grille and push the lever sideways with your
fingertips.
3. Raise the hood
*
3
.
4. Remove the support rod
*
4
and insert it into the
slot
*
5
.
Avoid direct contact with the metal parts, as they
may be hot immediately after the engine has
been stopped.
CLOSING HOOD
E12-A-120227-9564ED64-C15A-44B3-B4A6-4E130D1D67E3
1. While supporting the hood, return the support rod
to its original position.
2. Slowly lower the hood to about 20 to 30 cm (8 to
12 in) above the hood lock, then let it drop.
3. Make sure it is securely latched.
GUID-AB7CBA89-A055-4BDD-B6E2-FD69775E0BDE
WARNING:
. Make sure the rear hatch has been closed
securely to prevent it from opening while
driving.
. Do not drive with the rear hatch open. This
could allow dangerous exhaust gases to be
drawn into the vehicle.
CAUTION:
. Before opening the rear hatch, be sure to
clear away snow, ice or dust that may be
stuck to the rear hatch. If the rear hatch is
opened while materials are still stuck to it, it
may suddenly close again due to the weight
of these materials.
. Always be sure to fully open the rear hatch.
If it is not fully opened, it may suddenly shut.
. Be especially careful when opening the rear
hatch in strong wind. The door could be
caught by a gust of wind and may close
suddenly.
JVP0128X
Pre-driving checks and adjustments 3-13
REAR HATCH
Condition:
To Next Page
Loading...