Your vehicle has either or both of the following se-
curity systems:
•
Theft warning
•
NISSAN Anti-Theft System (NATS)*
The security condition will be shown by the security
indicator light.
(* immobilizer)
THEFT WARNING SYSTEM
(where fitted)
The theft warning system provides visual and audio
alarm signals if parts of the vehicle are disturbed.
Security indicator light
The security indicator light, located on the meter
panel, operates whenever the ignition switch is in
the LOCK, “OFF” or ACC position. This is normal.
How to activate system:
1. Close all windows.
2. Push the ignition switch to the “OFF” position
(models with Intelligent Key system) or remove
the key from the ignition switch (models without
Intelligent Key system).
3. Close and lock all doors and the bonnet. The
doors can be locked with the integrated keyfob
or the Intelligent Key system (where fitted).
If a door or the bonnet is open, the buzzer will
sound. The buzzer will stop when the door or
bonnet is correctly closed.
4. Confirm that the security indicator light comes
on. The security indicator light blinks rapidly for
about 20 seconds and then blinks slowly. The
system is now activated. If, during this 20-sec-
ond time period, the door is unlocked by the inte-
grated keyfob or the Intelligent Key system
(where fitted), or the ignition switch is turned to
the ON position, the system will not activate.
Even when the driver and/or passengers are in
the vehicle, the system will activate with all the
doors locked and the ignition switch off. Place
the ignition switch in the ON position to turn the
system off.
If the system malfunctions, the short beep
sounds 5 times when the system is activated.
Have the system checked by a NISSAN dealer or
qualified workshop.
Theft warning system operation:
The warning system will give the following alarm:
•
The hazard indicator blinks and the horn sounds
intermittently for 28 seconds. (The alarm will re-
peat 8 times.)
•
The alarm automatically turns off after the preset
time has expired. However, the alarm reactivates
if the vehicle is tampered with again.
The alarm is activated when:
•
operating the door without using the integrated
keyfob or the Intelligent Key system (where fit-
ted).
•
operating the bonnet.
•
the ignition circuit is turned on without the own-
er’s key being used.
How to stop alarm:
•
The alarm will stop only by unlocking a door by
pushing the “UNLOCK” button on the integrated
keyfob or Intelligent Key (where fitted).
•
The alarm will not stop if the ignition switch is
turned to the ON position.
SIC2045Z
SECURITY SYSTEM
Pre-driving checks and adjustments 3-17
To Next Page
Loading...