Forward and backward:
1. Pull up the adjusting lever j1.
2. Slide the seat to the desired position.
3. Release the adjusting lever to lock the seat in
position.
Reclining:
1. Pull up the adjusting lever
j2.
2. Tilt the seatback to the desired position.
3. Release the adjusting lever to lock the seatback
in position.
The reclining feature allows the adjustment of the
seatback for occupants of different sizes to help
obtain the proper seat belt fit (see “Seat belts” later
in this section).
The seatback may be reclined to allow occupants to
rest when the vehicle is parked.
Seat lifter (where fitted):
Pull up or push down the adjusting lever
j3 to ad-
just the seat height until the desired position is
achieved.
Heated seats (where fitted):
The seats can be warmed by built-in heaters. The
switches located on the centre console can be op-
erated independently of each other.
1. Start the engine.
2. Select heat range.
•
For high heat, push the HI (High) side of the
switch
j1.
•
For low heat, push the LO (Low) side of the
switch
j2.
•
The indicator light j3 will illuminate when low
or high is selected.
3. To turn the heater off, return the switch to the
level position. Make sure the indicator light turns
off.
The heater is controlled by a thermostat, automati-
cally turning the heater on and off. The indicator light
will remain on as long as the switch is on.
When the vehicle’s interior is warmed, or before you
leave the vehicle, be sure to switch the heated seats
off.
CAUTION
•
The battery could run down if the seat heater
is operated while the engine is not running.
•
Do not use the seat heater for extended peri-
ods or when no one is using the seat.
•
Do not put anything on the seat which insu-
lates heat, such as a blanket, cushion, seat
cover, etc. Otherwise, the seat may become
overheated.
•
Do not place anything hard or heavy on the
seat or pierce it with a pin or similar object.
This may result in damage to the seat heater.
JVR0086XZ
NPA1325
Safety — seats, seat belts and supplemental restraint system 1-3
To Next Page
Loading...