– When folding the rear seatback be careful
not to scratch or damage the seat belt, or
the seat belt path
jA.
– After returning the rear seatback to its
original position, pass the seat belt
through the path
jA.
jA
Passenger compartment side
jB
Luggage compartment side
Forward and backward
The rear bench seat can be moved forward and
backward by pulling the bar
jA , located below the
rear seat cushion, and sliding the seat forward or
backward.
It can also be moved forward or backward from the
luggage compartment
jB by first, releasing the
handle lock lever
j1 , then pushing or pulling the
handle
j2.
Folding
Luggage compartment loading capacity can be in-
creased by folding the rear seats forward.
1. Route the outer seat belt(s) between the seat(s)
through the seat belt guide(s)
j1.
2. Lower the head restraints to the stowed position.
Remove the parcel shelf/ tonneau board (See
“Tonneau board” in the “2. Instruments and
controls” section).
CAUTION
Make sure the seat backs are fully folded flat
before loading.
3. Lift up the outer seat release lever(s)
j2 , then
fold the seatback(s) down
j3.
NPA714Z
Type B
NPA715Z
Type B
Safety — seats, seat belts and supplemental restraint system 1-5
To Next Page
Loading...