2. Remove the seat belt from the path jA.
3. Retract the seat belt and store the seat belt
tongue and connector tongue on the stowed po-
sition
j3.
WARNING
•
Do not unfasten the rear centre seat belt con-
nector except when folding down the rear
seat.
Attaching rear centre seat belt:
Always be sure the rear centre seat belt connector
tongue and connector buckle are attached. Discon-
nect only when folding down the rear seat.
To connect the buckle:
1. Pull the seat belt tongue and connector tongue
from the stowed position
j1.
2. Install the seat belt to the path
jA.
3. Pull the seat belt and secure the connector
buckle until it clicks
j2.
The centre seat belt buckle is identified by the CEN-
TER mark. The centre seat belt tongue can be fas-
tened only into the centre seat belt buckle.
To fasten the seat belt, see “Fastening seat belts”
earlier in this section.
WARNING
•
When attaching the rear centre seat belt con-
nector, be certain that the seatbacks are com-
pletely secured in the latched position and
the rear centre seat belt connector is com-
pletely secured.
•
If the rear centre seat belt connector and the
seatbacks are not secured in the correct posi-
tion, serious personal injury may result in an
accident or sudden stop.
SEAT BELT MAINTENANCE
Periodically check that the seat belt and all the metal
components, such as buckles, tongues, retractors,
flexible wires and anchors, work properly. If loose
parts, deterioration, cuts or other damage on the
seat belt webbing is found, the entire seat belt as-
sembly should be replaced.
If dirt builds up in the shoulder belt guide of the seat
belt anchors, the seat belts may retract slowly. Wipe
the shoulder belt guide with a clean, dry cloth.
JVR0004XZ
1-12 Safety — seats, seat belts and supplemental restraint system
To Next Page
Loading...