REMOVE
Use the following procedure to remove the
head restraint/headrest:
1. Pull the head restraint/headrest up to
the highest position.
2. Push and hold the lock knob.
3. Remove the head restraint/headrest
from the seat.
4. Store the head restraint/headrest
properly in a secure place so it is not
loose in the vehicle.
5. Reinstall and properly adjust the head
restraint/headrest before an occupant
uses the seating position.
INSTALL
1. Align the head restraint/headrest
stalks with the holes in the seat. Make
sure that the head restraint/headrest is
facing the correct direction. The stalk
with the notch (notches)
䊊
1
must be
installed in the hole with the lock knob
䊊
2
.
2. Push and hold the lock knob and push
the head restraint/headrest down.
3. Properly adjust the head
restraint/headrest before an occupant
uses the seating position.
LRS2302 LRS2303
1-8 Safety—Seats, seat belts and supplemental restraint system
To Next Page
Loading...