Need help?Do you have a question about the Nissei PS30SW II and is the answer not in the manual?
Main switch to turn the power supply on or off.
LED indicator that shows output status.
Selects between voltage (V) and current (A) display.
Variable control for output voltage between 9-15V.
Output terminal suitable for currents up to 10A.
Additional output terminal for currents up to 3A.
Connectors for output, red for positive (+), black for negative (-).
Switch to select fixed 13.8V or variable 9-15V output.
Internal fan for heat dissipation during operation.
Houses the main fuse for protection; use F5A250V for replacement.
Operate in a dry, ventilated area; keep fan clear (30cm).
Turn off power before hookup; check polarity and tighten terminals.
Respect load limits: 10A for cigarette plug, 3A for testing terminal.
Avoid direct connection to batteries or low resistance loads.
Cut power on overload/short-circuit, analyze, and reset when clear.
Use specified fuse; do not open chassis due to high voltage.
Consult professionals for any malfunctions.
Main switch to turn the power supply on or off.
LED indicator that shows output status.
Selects between voltage (V) and current (A) display.
Variable control for output voltage between 9-15V.
Output terminal suitable for currents up to 10A.
Additional output terminal for currents up to 3A.
Connectors for output, red for positive (+), black for negative (-).
Switch to select fixed 13.8V or variable 9-15V output.
Internal fan for heat dissipation during operation.
Houses the main fuse for protection; use F5A250V for replacement.
Operate in a dry, ventilated area; keep fan clear (30cm).
Turn off power before hookup; check polarity and tighten terminals.
Respect load limits: 10A for cigarette plug, 3A for testing terminal.
Avoid direct connection to batteries or low resistance loads.
Cut power on overload/short-circuit, analyze, and reset when clear.
Use specified fuse; do not open chassis due to high voltage.
Consult professionals for any malfunctions.
General| Model | PS30SW II |
|---|---|
| Manufacturer | Nissei |
| Category | Power Supply |
| Output Voltage | 0-30V |
| Output Current | 0-3A |
| Output Power | 90W |
| Voltage Regulation | ≤ 0.01% + 3mV |
| Ripple and Noise | ≤ 1mVrms |
| Display Type | LED |
| Voltage Resolution | 10mV |
| Current Resolution | 1mA |
| Weight | 3.5 kg |
| Cooling Method | Fan |
| Operating Temperature | 0°C to 40°C |
| Protection Features | Overload, Short Circuit, Over Temperature |
To Next Page
