Note: The stated data is measured in accordance with the international flashlight testing standards ANSI/NEMA FL1,
using the built-in Li-ion battery (3.7V 650mAh) under laboratory conditions. The data may vary in real world use due
to different battery usage or environmental conditions.
Charging Function
The NU25 / NU25 UL is equipped with an intelligent charging system.
Please charge the battery before the first use.
Power Connection: As illustrated, uncap the charging port and use the
USB cable to connect an external power supply to the charging port to
begin the charging process.
Charging Indication: During the charging process, 4 power indicators on
the top will flash to inform the user. When the battery is fully charged, 4
power indicators will become steadily turned on. The charging time is
approx. 1h 25min. When fully charged, the standby time is approx. 12
months.
Power Button / MODE Button
The Power Button is used for turning on / off the light and adjusting
brightness levels.
The MODE Button is designed for switching light sources.
Turn On / Turn Off
When the light is off, long press the Power Button for 1 second to access LOW in Mix Mode.
When the light is on, long press the Power Button or MODE Button for 1 second to turn it off.
White Light
When the light is off, long press the Power Button for 1 second to access LOW in Mix Mode.
When the light is off, double press the Power Button to access ULTRALOW.
When the Mix Mode is on, short press the Power Button to cycle through the following brightness levels: LOW –
MID – HIGH.
When the Spotlight / Floodlight is on, short press the Power Button to switch between LOW and MID.
Red Light
When the light is off, long press the MODE Button for 1 second to turn on the Red Light.
When the Red Light is on, short press the Power Button to switch between CONSTANT-ON and SLOW FLASHING.
Light Sources Switching
When the light is on, short press the MODE Button to cycle through the following light sources: Mix – Spotlight –
Floodlight – Red Light.
Special Modes (SOS / BEACON)
When the headlamp is in any status, double press the MODE Button to access SOS.
When either special mode is on, short press the Power Button to switch between SOS and BEACON. Double press
the MODE Button again to return to the previous status.
64m 45m 24m 58m 31m 23m 12m 4m 8m ─ ─ ─
,
525cd 150cd 862cd 253cd 138cd 39cd 4cd 15cd ─ ─ ─
1m (Impact Resistance)
IP66
To Next Page
Loading...
