Features
T h e IF 3 2 e n a b le s t h e c o n v e r s io n o f a s t a n d a r d
D M X s ig n a l t o t w o s e t s o f 1 6 a n a lo g u e o u t p u t s o f
0 › 1 0 V. P o w e r e d fr o m a n y N J D p o w e r p a c k , t h e
IF 3 2 r e q u ir e s n o m a in s p o w e r s u p p ly a n d w ill a llo w
e a c h s e t o f 1 6 o u t p u t s t o b e a s s ig n e d t o a n y 1 6
c o n s e c u t ive D M X a d d r e s s e s . S u p p lie d in a 1 U r a c k
m o u n t c a s e w it h a ll e xt e r n a l c o n n e c t io n s t h e IF 3 2
fe a t u r e s IN a n d O U T D M X s o c k e t s a llo w in g it t o b e
in t r o d u c e d a t a n y p o in t in t h e D M X s ig n a l s u p p ly
lin e .
Installat ion.
Connect the incoming DMX signal to the ¼” jack socket
marked DMXin. Continue the DMX chain from the ¼” jack socket
marked DMXout to the next item in the DMX control chain.
The IF32 will operate with either switching of dimming power
packs (such as the DP5000, DP10000 and SP10000) provided
that they have a +15V output.
To Connect to an NJ D rack›mount ed
power pack (DP1 00 00 x or SP1 00 0 0 x)
Use a 7-pin DIN-DIN straight wired lead i.e. pin 1 - pin 1, pin
2 - pin 2, pin 3 - pin 3 etc. Connect from the output of the IF32 to
the input of the power pack. Ensure that the +10V terminal inside
the power pack is linked to the ENABLE terminal.
To connect t o an NJD wall mounted
power pack (DP1 00 00 or SP1 00 00 )
Connect a lead from the 7-pin DIN socket output of the IF32
to the ANALOGUE INPUTS terminal block of the power pack.
© N.J.D. Electronics 1997 -Page 3-
IF32 User Guide
To Next Page
Loading...