To Next PageTo Next Page
Need help?Do you have a question about the NKE Gyropilot 90-60-247 and is the answer not in the manual?
General| Brand | NKE |
|---|---|
| Model | Gyropilot 90-60-247 |
| Category | Transmitter |
| Language | English |
Controls autopilot for course, tack, and pilot mode changes.
Controls TL25, SL50, DL18, and Performance Multifunction displays.
Integrates solely the "man over board" safety function.
Diagram showing the system's components and their connections.
Details Auto, Stop, course adjustment, and tacking keys for autopilot control.
Explains how to activate the Man Over Board function using specific keys.
Describes keys for display selection, screen changes, data adjustment, and lighting.
Explains how to activate the Man Over Board function.
Details activation and deactivation using the On/Off key.
Explains alarm trigger, display output, and Gyropilot behavior in different modes.
Covers audible alarm, NMEA data, and external relay connections.
Steps to activate/deactivate MOB for the Gyropilot transmitter.
Steps to activate/deactivate MOB for the Multifunction transmitter.
Notes on activating MOB for the Crew transmitter.
Explains how the MOB function auto-deactivates due to inactivity.
Procedures for acknowledging and suspending MOB alarms.
Details power supply, IP rating, weight, and operating temperatures.
States that initialisation/pairing is done via the radio receiver installation guide.
Identifies the specific model of the universal radio receiver.
Identifies the manufacturer and their specialization.
Explains how the receiver interfaces with TOPLINE transmitters and displays.
Lists the three types of TOPLINE transmitters that communicate with the receiver.
Explains MOB alarm triggers, display information, and audible alarm.
Details Gyropilot's automatic mode changes during MOB incidents.
Procedures for suspending and disabling MOB alarms.
Lists items included in the receiver package and available accessories.
General precautions for installing the radio system components.
Guidance on positioning the offset antenna for optimal reception.
Illustrates radio spectrum for vertical and horizontal antenna positions.
Recommends installing offset antenna outside hull, considering metal/carbon material.
Details the need for 5cm insulating material between antennas and walls.
Instructions for placing the non-waterproof receiver housing and mounting bracket.
Advises checking radio reception quality before permanently fitting components.
Steps to connect the receiver's bus cable to the TOPLINE terminal box.
Details the identification of receiver cable wires and their connection to the Topline bus.
Explains the two alarm outputs for external relays and their activation times.
Provides a diagram for connecting relays and specifies maximum current.
Explains that transmitters must be paired with the receiver at first power-up.
Details the initialization button and status indicator lights on the receiver.
Notes on pairing all devices simultaneously and disabling MOB function beforehand.
Instructions on how to initialize the radio receiver.
Step-by-step guide for pairing the Gyropilot transmitter with the receiver.
Step-by-step guide for pairing the Multifunction transmitter.
Step-by-step guide for pairing the Crew transmitter.
Procedure for setting an address for the radio receiver on the TOPLINE bus.
Solutions for when the TOPLINE bus does not detect the radio receiver.
Troubleshooting intermittent audible signals from the radio receiver.
Addresses issues where transmitters stop acting on displays or controlling the pilot.
Solutions for the Crew transmitter not triggering the MOB alarm.
Details range, frequency, sensitivity, tightness, weight, and temperature for receiver and antenna.
States compliance with EMC standards and provides declaration details.
