Should there be no cable and/or plug on the equip-
ment, use suitable absorption material for the wor-
king temperature as well, as indicated on the matrix
plate. Under no circumstance must the cable reach
a temperature above 50°C of the ambient tempera-
ture.
Insert in the fixed wiring a mean for disconnection
from the supply mains having a contact separation in
all poles that provide full disconnection under over-
voltage category III conditions, in accordance with
the wiring rules. The plug or omnipolar switch must
be easily reached on the installed equipment.
This appliance is not intended to be used via an ex-
ternal timer or a remote control system.
The manufacturers decline any responsibility in the
event of non-compliance with what is described
above and the accident prevention norms not being
respected and followed.
To avoid all risk, if the power cable becomes dama-
ged, it must only be replaced by the manufacturer,
by an authorised service centre, or by a qualified
electrician.
To Next Page
Loading...
