RH-53/54
Nokia Customer Care
58 COMPANY CONFIDENTIAL Issue 2 06/2005
Copyright © 2005 Nokia. All Rights Reserved.
■ RF control
The purpose is to check the receiver or transmitter without going in call. It works very much like
a call, but you have control via the PC, and not via the tester. If you want to tune or calibrate at
other channels or levels than the default for that function, you can activate RF control at the
same time and change the wanted parameters.
If you want to tune at other channels than the default, then you must select it first in RF control
and then start the tuning.
To Next Page
Loading...
