RH-53/54
Nokia Customer Care
62 COMPANY CONFIDENTIAL Issue 2 06/2005
Copyright © 2005 Nokia. All Rights Reserved.
Press the Save&Continue botton
Note! You have to follow the shown procedure. It is not possible to tune the high band alone.
You need to make a tuning of the low band first to come to the high band. You can stop at any
time by switching off the menu. If the values are outside internal specs, you can not save them
and have to leave the tuning without saving.
■ RX Band Filter Response
Normally not needed in repair.
■ Tx Power tuning
Select Tuning, Tx Power Level Tuning
Figure 52:TX tuning
Press start and follow the instructions in the pop-up window
Figure 53:TX tuning
To Next Page
Loading...
