[ 41 ]
Settings
Note:
Charges may apply for certain types of received calls, such as
roaming and high-speed data calls. Contact your GSM service
provider for more information.
Note:
The phone expects the callback call to use the same data call settings
that were used in the callback-requesting call. The system must
support this type of call in both directions, to and from the phone.
• Callback type - The options are
Use server no.
/
Use other no.
Ask your
service provider for the correct setting; it will depend on the service
provider’s configuration.
• Callback number
- Key in your phone’s data phone number which the
dial back server uses. Usually, this number is the data call phone
number of your phone.
• Use PPP compression
- When set to
Yes
, this option speeds up the
data transfer, if supported by the remote PPP server. If you have
problems with establishing a connection, try setting this to
No
.
Contact your service provider for guidance.
Glossary:
PPP (Point-to-Point Protocol) - a common networking
software protocol that enables any computer with a modem and
a phone line to connect directly to the Internet.
• Use login script - The options are
Yes
/
No
.
• Login script - Insert the login script.
• Modem initialization - (Modem initialization string) - Controls your
phone using modem AT commands. If required, enter characters specified
by your GSM system service provider or Internet service provider.
To Next Page
Loading...
