6700 classic RM-470
Service Manual Level 1&2
ISSUE 3
Confidential
19
27
28
Note that the LCD is still attached to the C COVER with
the LCD Connector.
Lift up and slide the LCD carefully as shown in the
picture to get access to the LCD Connector. Then
release the Connector with the SS-93 tool.
29
30
Remove the LCD. In case the copper tracks between the C COVER and the
display are damaged after removing the display, a foil
including new tracks is available as a spare part
(9406181). This spare part includes the LCD adhesives
which should not be replaced. It is therefore necessary
to transfer the copper tracks from the spare foil to the
C COVER. The tracks can be straightened out using the
flat end of the SS-93 tool.
Copyright @ 2008 NOKIA. All rights reserved
To Next Page
Loading...
