Nokia 7210 SAS-M Configuration Guide

Interface Configuration
7210 SAS M, T, X, R6, R12, Mxp, S, Sx Interface Configuration Guide Page 135
Configuring LAG Parameters
LAG configurations should include at least two ports. Other considerations include:
• A maximum of four ports can be included in a LAG. All ports in the LAG must share the
same characteristics (speed, duplex, hold-timer, etc.). The port characteristics are
inherited from the primary port.
• Autonegotiation must be disabled or set limited mode for ports that are part of a LAG to
guarantee a specific port speed.
• Ports in a LAG must be configured as full duplex.
The following example displays LAG configuration output:
*A:7210SAS>config>lag# info detail
----------------------------------------------
no mac
mode hybrid
encap-type dot1q
no enable-dei
port 6/1/1 priority 32768 sub-group 1
no dynamic-cost
lacp active administrative-key 32770
port-threshold 0 action down
lacp-xmit-interval fast
lacp-xmit-stdby
no selection-criteria
no hold-time
standby-signaling lacp
no shutdown
----------------------------------------------
*A:7210SAS>config>lag#

Nokia 7210 SAS-M Specifications

General

Brand	Nokia
Model	7210 SAS-M
Category	Cell Phone
Language	English