Generic Commands
Page 160 7210 SAS M, T, X, R6, R12, Mxp, S, Sx Interface Configuration Guide
Parameters card-type — The type of card to be configured and installed in that slot.
Values 7210 SAS-M, 7210 SAS-Mxp, and 7210 SAS-Sx/S 1/10GE- iom-sas
Values 7210 SAS-R6 - imm-sas-10sfp+1xfp|imm-sas-10sfp|imm-sas-2xfp| imm-sas-b-
4sfp+|imm-sas-b-2sfp+|imm-sas-b-10sfp-1sfp+| imm-sas-b-11csfp|imm-sas-b-16tx
7210 SAS-R12 - imm-sas-b-4sfp+|imm-sas-b-4xfp|imm-sas-b-2sfp+| imm-sas-b-10sfp-
1sfp+|imm-sas-b-11csfp|imm-sas-b-16tx
sys-res-profile
Syntax [no] sys-res-profile policy-id
Context config>card
Description Platforms Supported: 7210 SAS-R6 and 7210 SAS-12.
This CLI command provides the context to the attach the system resource-profile policy. It is supported only
on 7210 SAS-R6 and 7210 SAS-R12. On 7210 SAS-R6 and 7210 SAS-R12 devices, the system resource
profile parameters are defined as a policy. User needs to configure the system resource profile policy and
associate it with the IMM card. The software reads the configured policy and allocates resources
appropriately per IMM card. It allows users to allocate resource to different features per IMM card.
NOTE: On 7210 SAS-R6 and 7210 SAS-R12, some of the system resource profile parameters are applicable
to the entire node and not per IMM card.
For more information on the CLI descriptions for System Resource Profile parameters, see the 7210 SAS-M,
T, X, R6, R12, Mxp, Sx Basics System Guide.
Default By default, the system attaches the default system resource-profile to each IMM when it is booted up.
Parameters policy-id — Specifies the system resource profile policy to use for this card.
Values [1-16]
To Next Page
Loading...
Need help?
General
