Interface Configuration
7210 SAS M, T, X, R6, R12, Mxp, S, Sx Interface Configuration Guide Page 165
qos
Syntax qos policy-id
no qos
Context config>port>ethernet>access>egress
Description Platforms Supported: 7210 SAS-M, 7210 SAS-T (Access-uplink mode and network mode)
7210 SAS-X, 7210 SAS-Sx/S 1/10GE, 7210 SAS-Sx 10/100GE, 7210 SAS-Mxp, 7210 SAS-R6, and 7210
SAS-R12.
This command associates a access-egress QoS policy to the access port.
On 7210 SAS-M and 7210 SAS-T in access uplink mode, this policy is used to enable port-based marking
and configuring port-based queue parameters. For more information, see QoS User Guide.
On 7210 SAS-M and 7210 SAS-T in network mode, this policy is used to enable port-based marking and
configuring port-based queue parameters. For more information, see QoS User Guide.
On 7210 SAS-X this policy is used to enable port-based marking and configure values to use marking. For
more information, see QoS User Guide.
On 7210 SAS-Mxp, 7210 SAS-R6, 7210 SAS-R12, when SAP based egress queuing is configured, this
policy is to used configure only marking values for packets sent out of access ports. For more information,
see QoS User Guide.
On 7210 SAS-Mxp, 7210 SAS-R6, 7210 SAS-R12, when port-based queues are used on access ports, this
policy is used to configure marking values and to configure the port-based queue parameters. For more
information, see QoS User Guide.
On 7210 SAS-Sx/S 1/10GE and 7210 SAS-Sx 10/100GE, this policy is used to enable port-based marking
and configuring port-based queue parameters. For more information, see QoS User Guide.
The no form of the policy removes the explicit association of a user configured QoS policy and associates a
default QoS policy with the port.
Parameters policy-id — Specifies an existing QoS policy to be assigned to the port.
Values 1 — 65535
qos
Syntax qos policy-id
no qos
Context config>port>ethernet>access>uplink
Description Platforms Supported: 7210 SAS-M, and 7210 SAS-T (Access-uplink mode and network mode).
This command associates a network QoS policy to the access uplink port.