Interface Configuration
7210 SAS M, T, X, R6, R12, Mxp, S, Sx Interface Configuration Guide Page 179
Default network — for Ethernet ports
Parameters access — Configures the Ethernet port as service access.
network — Configures the Ethernet port for transport network use.
hybrid — Configures the Ethernet port for hybrid use.
access
Syntax access
Context config>port>ethernet
Description Platforms Supported: 7210 SAS-M, 7210 SAS-X, 7210 SAS-Mxp, 7210 SAS-Sx/S 1/10GE,7210 SAS-Sx
10/100GE, 7210 SAS-R6, 7210 SAS-R12, 7210 SAS-T.
This command configures Ethernet access port QoS parameters.
egress
Syntax egress
Context config>port>ethernet>access
Description Platforms Supported: 7210 SAS-M, 7210 SAS-X, 7210 SAS-Mxp, 7210 SAS-Sx/S 1/10GE,7210 SAS-Sx
10/100GE, 7210 SAS-R6, 7210 SAS-R12, 7210 SAS-T.
This command configures Ethernet access egress port QoS parameters.
autonegotiate
Syntax autonegotiate [limited]
[no] autonegotiate
Context config>port>ethernet
Description Platforms Supported: 7210 SAS-M, 7210 SAS-X, 7210 SAS-Mxp, 7210 SAS-Sx/S 1/10GE,7210 SAS-Sx
10/100GE, 7210 SAS-R6, 7210 SAS-R12, 7210 SAS-T.
This command enables speed and duplex autonegotiation on Fast Ethernet ports and enables far-end fault
indicator support on gigabit ports.
There are three possible settings for autonegotiation:
• “on” or enabled with full port capabilities advertised
• “off” or disabled where there are no autonegotiation advertisements
• “limited” where a single speed/duplex is advertised.