Interface Configuration
7210 SAS M, T, X, R6, R12, Mxp, S, Sx Interface Configuration Guide Page 185
Description This command configures the mode of OAM operation for this Ethernet port. These two modes differ in that
active mode causes the port to continually send out efm-oam info PDUs while passive mode waits for the
peer to initiate the negotiation process. A passive mode port cannot initiate monitoring activites (such as
loopback) with the peer.
Default active
Parameters active — Provides capability to initiate negotiation and monitoring activities.
passive — Relies on peer to initiate negotiation and monitoring activities.
transmit-interval
Syntax [no] transmit-interval interval [multiplier multiplier]
Context config>port>ethernet>efm-oam
Description Platforms Supported: 7210 SAS-M, 7210 SAS-X, 7210 SAS-Mxp, 7210 SAS-Sx/S 1/10GE,7210 SAS-Sx
10/100GE, 7210 SAS-R6, 7210 SAS-R12, 7210 SAS-T.
This command configures the transmit interval of OAM PDUs.
The minimum efm-oam session time-out value supported is 300 milliseconds. That is, user can configure
"transmit-interval 1 multiplier 3" as the minimum value.
Default transmit-interval 10 multiplier 5
Parameters interval — Specifies the transmit interval.
Values 1 — 600 (in 100 milliseconds)
multiplier multiplier — Specifies the multiplier for transmit-interval to set local link down timer.
Values 2 — 5
tunneling
Syntax [no] tunneling
Context config>port>ethernet>efm-oam
Description Platforms Supported: 7210 SAS-M, 7210 SAS-X, 7210 SAS-Mxp, 7210 SAS-Sx/S 1/10GE,7210 SAS-Sx
10/100GE, 7210 SAS-R6, 7210 SAS-R12, 7210 SAS-T.
This command enables EFM OAM PDU tunneling. Enabling tunneling will allow a port mode Epipe SAP to
pass OAM frames through the pipe to the far end.
The no form of the command disables tunneling.
Default no tunneling