Port Commands
Page 208 7210 SAS M, T, X, R6, R12, Mxp, S, Sx Interface Configuration Guide
Default No accounting policies are specified by default. You must explicitly specify a policy. If configured, the
accounting policy configured as the default is used.
Parameters policy-id — The accounting policy-id of an existing policy. Accounting policies record either service
(access) or network information. A network accounting policy can only be associated with the network
port configurations. Accounting policies are configured in the config>log>accounting-policy context.
Values 1 — 99
collect-stats
Syntax [no] collect-stats
Context config>port>ethernet>network
config>port>ethernet>access>uplink
Description Platforms Supported: 7210 SAS-M, 7210 SAS-X, 7210 SAS-Mxp, 7210 SAS-Sx/S 1/10GE,7210 SAS-Sx
10/100GE, 7210 SAS-R6, 7210 SAS-R12, 7210 SAS-T.
This command enables the collection of accounting and statistical data for the network interface. When
applying accounting policies, the data, by default, is collected in the appropriate records and written to the
designated billing file.
When the no collect-stats command is issued, the statistics are still accumulated by the cards, however, the
CPU does not obtain the results and write them to the billing file.
If the collect-stats command is issued again (enabled), then the counters written to the billing file will
include the traffic collected while the no collect-stats command was in effect.
Default no collect-stats
queue-policy
Syntax queue-policy name
no queue-policy
Context config>port>ethernet>access>uplink
config>port>ethernet>access>network
Description Platforms Supported: 7210 SAS-M, 7210 SAS-X, 7210 SAS-Mxp, 7210 SAS-Sx/S 1/10GE,7210 SAS-Sx
10/100GE, 7210 SAS-R6, 7210 SAS-R12, 7210 SAS-T.
This command associates a network queue policy with access-uplink port in access-uplink mode or a
network port or hybrid port in network mode of operation.
This command specifies the existing network queue policy which defines queue parameters such as CIR and
PIR rates, as well as forwarding-class to queue mappings. The network-queue policy is defined in the
config>qos>network-queue context.
Default default
Parameters name — Specifies an exisiting network-queue policy name.
To Next Page
Loading...
Need help?
General
