EasyManuals Logo

Nokia 7210 SAS-M Configuration Guide

Nokia 7210 SAS-M
394 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #21 background imageLoading...
Page #21 background image
Interface Configuration
7210 SAS M, T, X, R6, R12, Mxp, S, Sx Interface Configuration Guide Page 21
*A:7210SAS>show# card state
===============================================================================
Card State
===============================================================================
Slot/ Provisioned Type Admin Operational Num Num Comments
Id Equipped Type (if different) State State Ports MDA
-------------------------------------------------------------------------------
1 iom-sas up up 2
1/1 s48-t4-sfpp up up 52
A sfm-sas up up Active
===============================================================================
*A:7210SAS>show#
Sample output for 7210 SAS-Sx 10/100 GE:
*A:hw_sass_duth# show card state
===============================================================================
Card State
===============================================================================
Slot/ Provisioned Type Admin Operational Num Num Comments
Id Equipped Type (if different) State State Ports MDA
-------------------------------------------------------------------------------
1 up up 1
1/1 s48-t+4-sfpp up up 52
A sfm-sas up up Active
===============================================================================
*A:hw_sass_duth#
The 7210 SAS-R6 is a chassis based platform with 6 IMM slots and 2 CPM slots. On a chassis
based platform the slots must be provisioned. To pre-provision a chassis slot, the line card type
must be specified. System administrators or network operators can enter card type information for
each slot, allowing a range of card types in particular slots. From the range of card types, a card
and accompanying MDAs (if any) are specified. When a card is installed in a slot and enabled, the
system verifies that the installed card type matches the allowed card type. If the parameters do not
match, the card remains offline. A pre-provisioned slot can remain empty without conflicting with
populated slots. 7210 SAS-R6 supports only CPM and IMMs. It does not support any physical
removable MDAs. Software uses logical MDAs internally to represent the ports on the IMMs and
the MDA type is auto-provisioned by software when the IMMs are provisioned. Please check the
latest release notes for a list of supported card types (that is, CPM and IMMs). For more
information on installation of cards, see the 7210 SAS-R6 Installation Guides.
The 7210 SAS-R12 is a chassis based platform with 12 IMM slots and 2 CPM slots. On a chassis
based platform the slots must be provisioned. To pre-provision a chassis slot, the line card type
must be specified. System administrators or network operators can enter card type information for
each slot, allowing a range of card types in particular slots. From the range of card types, a card

Other manuals for Nokia 7210 SAS-M

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Nokia 7210 SAS-M and is the answer not in the manual?

Nokia 7210 SAS-M Specifications

General IconGeneral
BrandNokia
Model7210 SAS-M
CategoryCell Phone
LanguageEnglish

Related product manuals