Interface Configuration
7210 SAS M, T, X, R6, R12, Mxp, S, Sx Interface Configuration Guide Page 235
eth-test-enable
Syntax [no] eth-test-enable
Context config>eth-ring>path>eth-cfm>mep
Description Platforms Supported: 7210 SAS-M, 7210 SAS-X, 7210 SAS-Mxp, 7210 SAS-Sx/S 1/10GE,7210 SAS-Sx
10/100GE, 7210 SAS-R6, 7210 SAS-R12, 7210 SAS-T.
This command enables eth-test functionality on MEP. For this test to work, operators need to configure
ETH-test parameters on both sender and receiver nodes. The ETH-test then can be done using the following
OAM commands:
oam eth-cfm eth-test mac-address mep mep-id domain md-index association
ma-index [priority priority] [data-length data-length]
A check is done for both the provisioning and test to ensure the MEP is an Y.1731 MEP (MEP provisioned
with domain format none, association format icc-based). If not, the operation fails. An error message in the
CLI and SNMP will indicate the problem.
test-pattern
Syntax test-pattern {all-zeros | all-ones} [crc-enable]
no test-pattern
Context config>eth-ring>path>eth-cfm>mep>eth-test-enable
Description Platforms Supported: 7210 SAS-M, 7210 SAS-X, 7210 SAS-Mxp, 7210 SAS-Sx/S 1/10GE,7210 SAS-Sx
10/100GE, 7210 SAS-R6, 7210 SAS-R12, 7210 SAS-T.
This command configures the test pattern for eth-test frames.
The no form of the command removes the values from the configuration.
Parameters all-zeros — Specifies to use all zeros in the test pattern.
all-ones — Specifies to use all ones in the test pattern.
crc-enable — Generates a CRC checksum.
Default all-zeros
bit-error-threshold
Syntax bit-error-threshold bit-errors
Context config>eth-ring>path>eth-cfm>mep
Description Platforms Supported: 7210 SAS-M, 7210 SAS-X, 7210 SAS-Mxp, 7210 SAS-Sx/S 1/10GE,7210 SAS-Sx
10/100GE, 7210 SAS-R6, 7210 SAS-R12, 7210 SAS-T.
This command specifies the lowest priority defect that is allowed to generate a fault alarm.
To Next Page
Loading...
Need help?
General
