Nokia 7210 SAS-M Configuration Guide

Multi-Chassis Redundancy Commands
Page 242 7210 SAS M, T, X, R6, R12, Mxp, S, Sx Interface Configuration Guide
MC LAG Commands
mc-lag
Syntax [no] mc-lag
Context config>redundancy>multi-chassis>peer>mc-lag
Description Platforms Supported: 7210 SAS-M, 7210 SAS-X, 7210 SAS-Mxp, 7210 SAS-Sx/S 1/10GE,7210 SAS-Sx
10/100GE, 7210 SAS-R6, 7210 SAS-R12, 7210 SAS-T.
This command enables the context to configure multi-chassis LAG operations and related parameters.
The no form of this command administratively disables multi-chassis LAG. MC-LAG can be issued only
when mc-lag is shutdown.
hold-on-neighbor-failure
Syntax hold-on-neighbor-failure multiplier
no hold-on-neighbor-failure
Context config>redundancy>multi-chassis>peer>mc-lag
Description Platforms Supported: 7210 SAS-M, 7210 SAS-X, 7210 SAS-Mxp, 7210 SAS-Sx/S 1/10GE,7210 SAS-Sx
10/100GE, 7210 SAS-R6, 7210 SAS-R12, 7210 SAS-T.
This command specifies the interval that the standby node will wait for packets from the active node before
assuming a redundant-neighbor node failure. This delay in switch-over operation is required to
accommodate different factors influencing node failure detection rate, such as IGP convergence, or HA
switch-over times and to prevent the standby node to take action prematurely.
The no form of this command sets this parameter to default value.
Default 3
Parameters multiplier — The time interval that the standby node will wait for packets from the active node before
assuming a redundant-neighbor node failure.
Values 2 — 25
keep-alive-interval
Syntax keep-alive-interval interval
no keep-alive-interval
Context config>redundancy>multi-chassis>peer>mc-lag
Description Platforms Supported: 7210 SAS-M, 7210 SAS-X, 7210 SAS-Mxp, 7210 SAS-Sx/S 1/10GE,7210 SAS-Sx
10/100GE, 7210 SAS-R6, 7210 SAS-R12, 7210 SAS-T.

Nokia 7210 SAS-M Specifications

General

Brand	Nokia
Model	7210 SAS-M
Category	Cell Phone
Language	English