Hardware Commands
Page 276 7210 SAS M, T, X, R6, R12, Mxp, S, Sx Interface Configuration Guide
Output Show Pool Output — The following table describes show pool output fields.
*A:MTU-A# show pools 1/1/2 access-egress
Label Description
Type
Specifies the pool type.
ID
Specifies the card/mda or card/MDA/port designation.
Application/Type
Specifies the nature of usage the pool would be used for. The pools
could be used for access or network traffic at either ingress or egress.
Pool Name
Specifies the name of the pool being used.
Resv CBS
Specifies the percentage of pool size reserved for CBS.
Utilization
Specifies the type of the slope policy.
State
The administrative status of the port.
Start-AvgThresh-
old
Specifies the percentage of the buffer utilized after which the drop
probability starts to rise above 0.
Max-Avg
Specifies the percentage of the buffer utilized after which the drop
probability is 100 percent. This implies that all packets beyond this
point will be dropped.
Time Avg Factor
Specifies the time average factor the weighting between the previous
shared buffer average utilization result and the new shared buffer utili-
zation in determining the new shared buffer average utilization.
Actual ResvCBS
Specifies the actual percentage of pool size reserved for CBS.
Admin ResvCBS
Specifies the percentage of pool size reserved for CBS.
PoolSize
Specifies the size in percentage of buffer space. The value '-1' implies
that the pool size should be computed as per fair weighting between all
other pools.
Pool Total Displays the total pool size.
Pool Shared Displays the amount of the pool which is shared.
Pool Resv Specifies the percentage of reserved pool size.
Pool Total In
Use
Displays the total amount of the pool which is in use.
Pool Shared In
Use
Displays the amount of the shared pools that is in use.
MMU Configured
CBS
Displays the total amount of CBS buffers configured on the IMM
across all the queues on the IMM.
To Next Page
Loading...
Need help?
General
