Interface Configuration
7210 SAS M, T, X, R6, R12, Mxp, S, Sx Interface Configuration Guide Page 29
Nokia SFPs and XFPs
The availability of the DDM real-time information and warning or alarm status is based on the
transceiver. It may or may not indicate if DDM is supported, although some Nokia SFPs support
DDM. Non-DDM and DDM-supported SFPs are distinguished by a specific ICS value.
For Nokia SFPs that do not indicate DDM support in the ICS value, DDM data is available
although the accuracy of the information has not been validated or verified.
For non-Nokia transceivers, DDM information may be displayed, but Alcatel-Lucent is not
responsible for formatting, accuracy, etc.
Statistics Collection
The DDM information and warnings/alarms are collected at one minute intervals, so the minimum
resolution for any DDM events when correlating with other system events is one minute.
Note that in the Transceiver Digital Diagnostic Monitoring section of the show port port-id detail
command output:
• If the present measured value is higher than the either or both High Alarm, High Warn
thresholds; an exclamation mark “!” displays along with the threshold value.
• If the present measured value is lower than the either or both Low Alarm, Low Warn
thresholds; an exclamation mark “!” displays along with the threshold value.
A:Dut-A# show port 2/1/6 detail
.........
===============================================================================
Transceiver Digital Diagnostic Monitoring (DDM), Internally Calibrated
===============================================================================
Value High Alarm High Warn Low Warn Low Alarm
-------------------------------------------------------------------------------
Temperature (C) +39.3 +96.0 +94.0 -7.0 -8.0
Supply Voltage (V) 3.27 3.51 3.49 3.12 3.10
Tx Bias Current (mA) 18.8 77.0 70.0 5.5 4.5
Tx Output Power (dBm) 1.33 5.50 5.00 0.00 -0.50
Rx Optical Power (avg dBm) -40.00 -8.50 -9.00 -33.98! -35.23!
===============================================================================