Port Show Commands
Page 296 7210 SAS M, T, X, R6, R12, Mxp, S, Sx Interface Configuration Guide
Sample Output
*A:MTU-A# show port 1/1/1
===============================================================================
Ethernet Interface
===============================================================================
Description : 10/100/Gig Ethernet SFP
Interface : 1/1/1 Oper Speed : 1 Gbps
Link-level : Ethernet Config Speed : 1 Gbps
Admin State : up Oper Duplex : full
Oper State : up Config Duplex : full
Physical Link : Yes MTU : 1578
Single Fiber Mode : No : Internal
IfIndex : 35684352 Hold time up : 0 seconds
Last State Change : 06/27/2001 11:15:22 Hold time down : 0 seconds
Last Cleared Time : 06/27/2001 11:14:44
Configured Mode : network Encap Type : 802.1q
Dot1Q Ethertype : 0x8100 QinQ Ethertype : 0x8100
Net. Egr. Queue Pol: default Acc Egr Sch Mode : Fc-Based
Egr. Sched. Pol : default Access Egr. Qos *: n/a
Auto-negotiate : limited Network Qos Pol : n/a
Accounting Policy : None MDI/MDX : MDI
Collect-stats : Disabled
Down-when-looped : Disabled Keep-alive : 10
Loop Detected : False Retry : 120
Down On Int. Error : Disabled
CRC Mon SD Thresh : Enabled CRC Mon Window : 10 seconds
CRC Mon SF Thresh : Enabled
LLF Oper State
Displays the Link Loss Forwarding operational state.
Rx S1 Byte
Displays the received S1 byte and its decoded QL value.
Tx DUS/DNU
Displays whether the QL value is forcibly set to QL-DUS/QL-DNU.
Qinq etype
Displays the ethertype used for qinq packet encapsulation.
Reason down
Indicates the reason for an operation state "Down".
Acc Egr Sch Mode
Displays the port egress scheduler mode
Sync. Status Msg.
Enabled- If SSM is enabled.
Disabled-If SSM is disabled.
Code-Type
Displays the encoding type of SSM messages as SONET or SDH.
Acc Egr Marking
Displays the type of marking enabled on the access egress policy.
(supported only on SAS-X)
Acc Egr Policy ID
Displays the policy ID of the access egress policy associated with the
port.
(supported only on SAS-X)
Label Description (Continued)