Interface Configuration
7210 SAS M, T, X, R6, R12, Mxp, S, Sx Interface Configuration Guide Page 301
SQE Test Errors : 0 Late Collisions : 0
CSE : 0 Excess Collisns : 0
Too long Frames : 0 Int MAC Tx Errs : 0
Symbol Errors : 0 Int MAC Rx Errs : 0
===============================================================================
===============================================================================
Queue Statistics
===============================================================================
-------------------------------------------------------------------------------
Packets Octets
-------------------------------------------------------------------------------
Egress Queue 1 (be)
Fwd Stats : 112 20243
Drop Stats : 0 0
Egress Queue 2 (l2)
Fwd Stats : 0 0
Drop Stats : 0 0
Egress Queue 3 (af)
Fwd Stats : 0 0
Drop Stats : 0 0
Egress Queue 4 (l1)
Fwd Stats : 0 0
Drop Stats : 0 0
Egress Queue 5 (h2)
Fwd Stats : 0 0
Drop Stats : 0 0
Egress Queue 6 (ef)
Fwd Stats : 0 0
Drop Stats : 0 0
Egress Queue 7 (h1)
Fwd Stats : 0 0
Drop Stats : 0 0
Egress Queue 8 (nc)
Fwd Stats : 0 0
Drop Stats : 0 0
===============================================================================
*A:7210>config>port#
*A:7210>config>port# /show port 1/1/1 detail
===============================================================================
Ethernet Interface
===============================================================================
Description : 10/100/Gig Ethernet SFP
Interface : 1/1/1 Oper Speed : 100 mbps
Link-level : Ethernet Config Speed : 1 Gbps
Admin State : up Oper Duplex : full
Oper State : up Config Duplex : full
Physical Link : Yes MTU : 9212
Single Fiber Mode : No : None
IfIndex : 35684352 Hold time up : 0 seconds
Last State Change : 05/31/2010 11:54:16 Hold time down : 0 seconds
Last Cleared Time : N/A DDM Events : Enabled
Configured Mode : access Encap Type : null
Dot1Q Ethertype : 0x8100 QinQ Ethertype : 0x8100
PBB Ethertype : 0x88e7
Ing. Pool % Rate : 100 Egr. Pool % Rate : 100