Port Show Commands
Page 326 7210 SAS M, T, X, R6, R12, Mxp, S, Sx Interface Configuration Guide
Sample Output
*A:MTU-A#
===============================================================================
Ethernet-like Medium Statistics
===============================================================================
Alignment Errors : 0 Sngl Collisions : 0
FCS Errors : 0 Mult Collisions : 0
SQE Test Errors : 0 Late Collisions : 0
CSE : 0 Excess Collisns : 0
Too long Frames : 0 Int MAC Tx Errs : 0
Symbol Errors : 0 Int MAC Rx Errs : 0
===============================================================================
*A:MTU-A#
Port Associations Output Fields Port Associations Output — The following table describes port associations output fields.
Sample Output
*A:MTU-A>config# show port 1/1/23 associations
===============================================================================
Interface Table
===============================================================================
Router/ServiceId Name Encap Val
-------------------------------------------------------------------------------
Router: Base one 0
-------------------------------------------------------------------------------
Interfaces
===============================================================================
*A:MTU-A>config#
A1 Detailed Output — The following table describes A1 detailed output fields.
Label Description
Svc ID
The service identifier.
Name
The name of the IP interface.
Encap Value
The dot1q or qinq encapsulation value on the port for this IP interface
Label Description
Description A text description of the port.
Interface
The port ID displayed in the slot/mda/port format.
Oper Speed
The operating speed of the interface.
Link-level
Ethernet — the port is configured as Ethernet.
Config Speed
The configured speed of the interface.