Interface Configuration
7210 SAS M, T, X, R6, R12, Mxp, S, Sx Interface Configuration Guide Page 331
Sample output for 7210 SAS-X:
A:7210-SAS-X>show# port A/1
===============================================================================
Ethernet Interface
===============================================================================
Description : 10/100 Ethernet TX
Interface : A/1 Oper Speed : 100 mbps
Link-level : Ethernet Config Speed : 100 mbps
Admin State : up Oper Duplex : full
Oper State : up Config Duplex : full
Physical Link : Yes MTU : 1514
Single Fiber Mode : No
IfIndex : 67141632 Hold time up : 0 seconds
Last State Change : 11/10/2010 20:50:27 Hold time down : 0 seconds
Last Cleared Time : N/A
Configured Mode : network Encap Type : null
Dot1Q Ethertype : 0x8100 QinQ Ethertype : 0x8100
PBB Ethertype : 0x88e7
Ing. Pool % Rate : 100 Egr. Pool % Rate : 100
Ing. Pool Policy : n/a
Egr. Pool Policy : n/a
Net. Egr. Queue Pol: Network Qos Pol : n/a
Auto-negotiate : true MDI/MDX : MDI
Accounting Policy : None Collect-stats : Disabled
Egress Rate : Default Max Burst : Default
Load-balance-algo : default LACP Tunnel : Disabled
LACP Tunnel : Disabled
Down-when-looped : N/A Keep-alive : N/A
Loop Detected : N/A Retry : N/A
Use Broadcast Addr : N/A
Sync. Status Msg. : Disabled Rx Quality Level : N/A
Down On Int. Error : Disabled
CRC Mon SD Thresh : Enabled CRC Mon Window : 10 seconds
CRC Mon SF Thresh : Enabled
Configured Address : 7c:20:64:ad:00:f0
Hardware Address : 7c:20:64:ad:00:f0
Cfg Alarm :
Alarm Status :
===============================================================================
Traffic Statistics
===============================================================================
Input Output
-------------------------------------------------------------------------------
Octets 411179 0
Packets 5415 0
Errors 0 0
===============================================================================
===============================================================================
Port Statistics