Port Show Commands
Page 338 7210 SAS M, T, X, R6, R12, Mxp, S, Sx Interface Configuration Guide
EapStarts While Authenticated : 0
EapLogoffs While Authenticated : 0
Backend Responses : 0
Backend Access Challenges : 0
Backend Requests To Supplicant : 0
Backend Access Challenges : 0
Backend Non Nak Responses : 0
Backend Auth Successes : 0
Backend Auth Failures : 0
Detailed Sample for 7210 SAS-Sx 10/100GE
*A:NS1633T0067>show# port 1/1/1 detail
===============================================================================
Ethernet Interface
===============================================================================
Description : 1-Gig/10-Gig Ethernet
Interface : 1/1/1 Oper Speed : 0 mbps
Link-level : Ethernet Config Speed : 10 Gbps
Admin State : down Oper Duplex : full
Oper State : down Config Duplex : N/A
Physical Link : No MTU : 9212
Config Conn Type : N/A Oper Conn Type : N/A
Single Fiber Mode : No LoopBack Mode : None
Single Fiber Mode : Decommissioned : No
IfIndex : 35684352 Hold time up : 0 seconds
Last State Change : 01/01/2000 00:29:06 Hold time down : 0 seconds
Last Cleared Time : N/A DDM Events : Enabled
Phys State Chng Cnt: 0
Configured Mode : network Encap Type : null
Dot1Q Ethertype : 0x8100 QinQ Ethertype : 0x8100
PBB Ethertype : 0x88e7
Ing. Pool % Rate : 100 Egr. Pool % Rate : 100
Net. Egr. Queue Pol: default Network Qos Pol : 1
Egr. Sched. Pol : default Access Egr. Qos *: n/a
Auto-negotiate : N/A MDI/MDX : N/A
Accounting Policy : None Collect-stats : Disabled
Acct Plcy Eth Phys : None Collect Eth Phys : Disabled
Egress Rate : Default Max Burst : Default
LACP Tunnel : Disabled DEI Classificati*: Disabled
Split Horizon Group: (Not Specified)
Down-when-looped : Disabled Keep-alive : 10
Loop Detected : False Retry : 120
Use Broadcast Addr : False
Sync. Status Msg. : Disabled Rx Quality Level : N/A
Tx DUS/DNU : Disabled Tx Quality Level : N/A
SSM Code Type : sdh
Down On Int. Error : Disabled
CRC Mon SD Thresh : Disabled CRC Mon Window : 10 seconds
CRC Mon SF Thresh : Disabled