Port Show Commands
Page 342 7210 SAS M, T, X, R6, R12, Mxp, S, Sx Interface Configuration Guide
Description Platforms Supported: 7210 SAS-M, 7210 SAS-X, 7210 SAS-Mxp, 7210 SAS-Sx/S 1/10GE,7210 SAS-Sx
10/100GE, 7210 SAS-R6, 7210 SAS-R12, 7210 SAS-T.
This command displays Link Layer Discovery Protocol (LLDP) information.
Parameters nearest-bridge — Displays nearest bridge information.
nearest-non-tpmr — Displays nearest Two-Port MAC Relay (TPMR) information.
nearest-customer — Displays nearest customer information.
remote-info — Displays remote information on the bridge MAC.
detail — Shows detailed information.
Output Sample Output
*A:hw_sasm_duta>show# port 1/1/1 ethernet lldp
==============================================================================
Link Layer Discovery Protocol (LLDP) Port Information
==============================================================================
Port 1/1/1 Bridge nearest-bridge
-------------------------------------------------------------------------------
Admin State : disabled Notifications : Disabled
Tunnel Nearest Bridge : Disabled
Transmit TLVs : None
PortID TLV Subtype : tx-local
Management Address Transmit Configuration:
Index 1 (system) : Disabled Address : 0.0.0.0
Index 2 (IPv6 system) : Disabled Address : ::
Port 1/1/1 Bridge nearest-non-tpmr
-------------------------------------------------------------------------------
Admin State : disabled Notifications : Disabled
Transmit TLVs : None
PortID TLV Subtype : tx-local
Management Address Transmit Configuration:
Index 1 (system) : Disabled Address : 0.0.0.0
Index 2 (IPv6 system) : Disabled Address : ::
Port 1/1/1 Bridge nearest-customer
-------------------------------------------------------------------------------
Admin State : disabled Notifications : Disabled
Transmit TLVs : None
PortID TLV Subtype : tx-local
Management Address Transmit Configuration:
Index 1 (system) : Disabled Address : 0.0.0.0
Index 2 (IPv6 system) : Disabled Address : ::
==============================================================================
*A:hw_sasm_duta>show#