Nokia 7210 SAS-M Configuration Guide

Port Show Commands
Page 348 7210 SAS M, T, X, R6, R12, Mxp, S, Sx Interface Configuration Guide
Mac-swap Application Status — The following table describes Mac-swap Application Status
associations output fields.
lldp
Syntax lldp
lldp neighbor
Context show>system
Description Platforms Supported: 7210 SAS-M, 7210 SAS-X, 7210 SAS-Mxp, 7210 SAS-Sx/S 1/10GE,7210 SAS-Sx
10/100GE, 7210 SAS-R6, 7210 SAS-R12, 7210 SAS-T.
This command displays local Link Layer Discovery Protocol (LLDP) information at the system level. This
includes an option keyword to display summary information for all known peers.
Parameters neighbor — Display all peer summary information .
Sample Output
*A:hw_sasm_duta>show>system# lldp
===============================================================================
LLDP Configuration
===============================================================================
Transmit Interval : 30
Label Description
LoopBack Type The Loopback type indicates whether the port is in Physical Front
panel port or Internal Virtual port.
Application Application mentions the application in use of the port.
Service enabled The Service enabled displays, if services can be configured over this
port.
Enabled Displays the current status.
Test Service Id The service ID that is used in the configuration of Mac-swap test.
Test Sap Id The SAP ID that is used to configure the loopback SAP for the Mac-
swap application.
Loopback Src
Addr
The source MAC address that is used in the configuration of port
loopback mac-swap test.
Loopback Dst
Addr
The destination MAC address that is used in the configuration of port
loopback mac-swap test.

Nokia 7210 SAS-M Specifications

General

Brand	Nokia
Model	7210 SAS-M
Category	Cell Phone
Language	English