Interface Configuration
7210 SAS M, T, X, R6, R12, Mxp, S, Sx Interface Configuration Guide Page 353
LACP
Enabled — LACP is enabled.
Down — LACP is disabled.
LACP Transmit
Intvl
LACP timeout signaled to peer.
Selection Criteria
Configured subgroup selection criteria.
Number of sub-
groups
Total subgroups in LAG.
System ID
System ID used by actor in LACP messages.
Admin Key
Configured LAG key.
Oper Key
Key used by actor in LACP messages.
System Priority
System priority used by actor in LACP messages.
Prtr System ID
System ID used by partner in LACP messages.
Prtr Oper Key
Key used by partner in LACP messages.
Prtr System Prior-
ity
System priority used by partner in LACP messages.
Mode
LAG in access or network mode.
Opr
Up — The LAG is operationally up.
Down — The LAG is operationally down.
Port Threshold
Configured port threshold.
Thres. Exceeded
Cnt
The number of times that the drop count was reached.
Threshold Action
Action to take when the number of available links is equal or below the port
threshold.
Encap Type
The encapsulation method used to distinguish customer traffic on a LAG.
Lag-IFIndex
A box-wide unique number assigned to this interface.
Port ID
The specific slot/MDA/port ID.
(LACP) Mode
LACP active or passive mode.
LACP xmit standby
LACP transmits on standby links enabled / disabled.
Slave-to-partner
Configured enabled/disabled.
Port-id
Displays the member port ID.
Adm
Displays the member port administrative state.
Label Description (Continued)