7210 SAS M, T, X, R6, R12, Mxp, S, Sx Interface Configuration Guide Page 371
Standards and Protocol Support
BGP
draft-ietf-idr-add-paths-04, Advertisement of Multiple Paths in BGP is supported on
M(N), T(N), X, Mxp, Sx/S-1/10GE, Sx-10/100GE, R6, and R12
draft-ietf-sidr-origin-validation-signaling-04, BGP Prefix Origin Validation State
Extended Community is supported on K12, M(N), T(N), X, Mxp, Sx/S-1/
10GE, Sx-10/100GE, R6, and R12
Note: The information presented is subject to change without notice.
Nokia assumes no responsibility for inaccuracies contained herein.
M(A,N) means 7210 SAS-M in both Access-uplink mode and Network mode; Similarly M(N)
means 7210 SAS-M in network mode only
T(A,N) means 7210 SAS-M in both Access-uplink mode and Network mode; Similarly T(N)
means 7210 SAS-T in network mode only
K5 means 7210 SAS-K 2F2T1C
K12 means 7210 SAS-K 2F4T6C
Sx/S-1/10GE means all variants of 7210 SAS-Sx 1/10GE and 7210 SAS-S 1/10GE
platforms
Sx-1/10GE means only the variants of 7210 SAS-Sx 1/10G
R6 means 7210 SAS-R6
R12 means 7210 SAS-R12
D means 7210 SAS-D and 7210 SAS-D ETR; if a line item applies to 7210 SAS-D ETR, then
it is indicated as D-ETR
E means 7210 SAS-E
X means 7210 SAS-X