Interface Configuration
7210 SAS M, T, X, R6, R12, Mxp, S, Sx Interface Configuration Guide Page 43
The following table lists the behavior for LLDP with different values set in use for admin-status
and when tunneling is enabled or disabled:
NOTE: Transparent forwarding of LLDP frames can be achieved using the standard defined
mechanism when using the either nearest-non-tmpr or the nearest-customer as the destination
MAC address in the LLDP frames. It is recommended that the customers use these MAC address
where possible to conform to standards. This command allows legacy LLDP implementations that
do not support these additional destinations MAC addresses to tunnel LLDP frames that use the
nearest-bridge destination MAC address.
Table 7: Behavior for LLDP with different values
Nearest-bridge-mac Admin status Tunneling Enabled Tunneling Disabled
Rx Process/Peer Process/Peer
Tx Tunnel Drop
Rx-Tx Process/Peer Process/Peer
Disabled Process/Peer Drop