Nokia 7210 SAS-M Configuration Guide

Interface Configuration
7210 SAS M, T, X, R6, R12, Mxp, S, Sx Interface Configuration Guide Page 91
Epipe service:
SAP to SDP
IP traffic: Source and Destination IP,
Source and Destination L4 ports
PBB traffic: BDA, BSA, EtherType
MPLS traffic: Source and Destination
MAC, VLAN
Non-IP traffic: Source and
Destination MAC, EtherType, VLAN
IP traffic: Source and Destination IP,
Source and Destination L4 ports, Ingress
Port-Id
PBB traffic: BDA, BSA, ISID,
EtherType, Ingress Port-Id
MPLS traffic: MPLS label stack (Three
labels deep), Source and Destination IP
(if MPLS labels are <= 3, when IP
header follows MPLS header), Ingress
Port-Id
Non-IP traffic: Source and Destination
MAC, EtherType, VLAN, Ingress Port-
Id
VPLS service:
SDP to SAP
IP traffic (Learnt): Source and
Destination MAC, MPLS Label Stack
(Two labels deep), Source and
Destination L4 ports, VLAN
PBB traffic (Learnt): BDA, BSA,
EtherType
Non-IP traffic(Learnt) : Source and
Destination MAC, EtherType
All traffic(Unlearnt): Hash-2 and
parameter under hash-2 used.
All traffic (Learnt and Unlearnt): Src &
dst MAC (Outer MACs inside the
payload, just after the MPLS header),
Ingress Port-Id.
Table 15: LAG Hashing mechanism for services configured on 7210 SAS-Sx/S 1/10GE and 7210 SAS-Sx
10/100GE devices (Continued)
Services and Traffic
direction (For example:
SAP to SDP)
Packet fields used for Hashing for
different traffic types with hash-1
Packet fields used for Hashing for dif-
ferent traffic types with hash-2

Nokia 7210 SAS-M Specifications

General

Brand	Nokia
Model	7210 SAS-M
Category	Cell Phone
Language	English