Ethernet Connection Fault Management
202
"FD 100/320Gbps NT and FX NT IHub System
Basics, Management and OAM Guide"
3HH-11982-AAAA-TQZZA Issue: 10
Accumulated Frames Near-End Far-End
Total Tx : 30 36
Total Rx : 35 30
Total Loss : 1 0
Loss Ratio(%) : 2.78 0.00
==================================================================
Table 236 shows the synthetic loss measurement test output fields.
Table 236 ETH-CFM MEP Synthetic Loss Measurement Test Field Descrip-
tions
Output example:
show eth-cfm mep 100 domain 3 association 1 two-way-slm-test
==================================================================
Eth CFM Two-way SLM Test Result Table (Test-id: 588)
==================================================================
Peer Mac Addr Remote MEP Count In Loss Out Loss Unack
------------------------------------------------------------------
d0:0d:1e:00:01:01 101 20 0 0 0
==================================================================
Label Description
Peer Mac Addr Displays the MAC address of the far-end (remote) node.
Remote MEP Remote MEP id.
Count The number of probes that are sent when the last frame is not lost. When the last
frame(s) is/are lost, the count + unacknowledged equals the number of probes sent.
In loss Packet loss on the way back from the remote node to the test initiator.
Out loss Packets lost on the way to the remote node, from test initiator to test destination.
Unack Number of packets at the end of the test that were not responded to.
To Next Page
Loading...
