Nokia 7705 - 4.1 Introduction to the Path Computation Element (PCE) Communication Protocol (PCEP)

System Management
306
Basic System Configuration Guide
3HE 11010 AAAC TQZZA Edition: 01
begin
external
input-interface
impedance {high-impedance | 50-ohm |
75-ohm}
no shutdown
ql-override {prs | stu | st2 | tnc | st3e
| st3 | smc | prc | ssu-a | ssu-b | sec
| eec1 | eec2}
type {2048khz-G703 | 5mhz | 10mhz}
commit
bits
input
[no] shutdown
interface-type {ds1[{esf|sf}] | e1[{pcm30crc |
pcm31crc}] | 2048khz-G703}
output
line-length {110|220|330|440|550|660}
[no] shutdown
ql-override {prs | stu | st2 | tnc | st3e | st3
| smc | prc | ssu-a | ssu-b | sec | eec1 |
eec2}
ssm-bit sa-bit
[no] shutdown
ql-selection
ref-order first second [third]
ref1
ql-override {prs | stu | st2 | tnc | st3e | st3
| smc | prc | ssu-a | ssu-b | sec | eec1 |
eec2}
source-port port-id adaptive
no shutdown
ref2
ql-override {prs | stu | st2 | tnc | st3e | st3
| smc | prc | ssu-a | ssu-b | sec | eec1 |
eec2}
source-port port-id adaptive
no shutdown
The following example shows the command usage:
Example: config>system# sync-if-timing
config>system>sync-if-timing# begin
config>system>sync-if-timing# external
config>system>sync-if-timing>external# input-interface
config>system>sync-if-timing>external>input-interface#
impedance 50-Ohm
config>system>sync-if-timing>external>input-interface#
no shutdown