CLI Usage
60
Basic System Configuration Guide
3HE 11010 AAAC TQZZA Edition: 01
Description This command changes a user CLI login password.
When a user logs in after the administrator forces a new-password-at-login, or the
password has expired (aging), then this command is automatically invoked.
When invoked, the user is prompted to enter the old password, the new password, and then
the new password again to verify the correct input.
If a user fails to create a new password after the administrator forces a new-password-at-
login or after the password has expired, the user is not allowed access to the CLI.
ping
Syntax ping {ip-address | dns-name} [rapid | detail] [ttl time-to-live] [tos type-of-service] [size bytes]
[pattern pattern] [source ip-address] [interval seconds] [{next-hop ip-address} |
{interface interface-name} | bypass-routing] [count requests] [do-not-fragment]
[router router-instance | service-name service-name] [timeout timeout] [fc fc-name]
Context <global>
Description This command is the TCP/IP utility to verify IP reachability.
Parameters ip-address — the IP address of the remote host to ping
Values ipv4-address a.b.c.d
ipv6-address x:x:x:x:x:x:x:x[-
interface]
x:x:x:x:x:x:d.d.d.d[-interface]
x: [0 to FFFF]H
d: [0 to 255]D
interface — 32 chars max, mandatory
for link local addresses
source ip-address — the source IP address to use in the ping requests
Values ipv4-address a.b.c.d
ipv6-address x:x:x:x:x:x:x:x (eight 16-bit pieces)
x:x:x:x:x:x:d.d.d.d
x: [0 to FFFF]H
d: [0 to 255]D
Default the IP address of the egress IP interface
next-hop ip-address — this option disregards the routing table and will send this packet
to the specified next hop address. This address must be on an adjacent router that
is attached to a subnet that is common between this and the next-hop router.
Values a valid IP next hop IP address
Default per the routing table
To Next Page
Loading...
